All resources
Fact sheet

Get the Lead Out: No-cost and low-cost solutions to eliminate lead at the tap in drinking and cooking water

Listed on this site as “No-cost and low-cost solutions to eliminate lead at the tap in drinking and cooking water”

Published by
RTI International
Published
RTI International
Format
2-page PDF

Two pages of things you can do about a tap, organized by what your test result said. Nothing here needs a budget line or a contractor to start with.

It is written for the person holding the result rather than for a regulator, which makes it the most directly usable thing on this list.

What it says

  • At any level: use cold water only for drinking and cooking, flush taps after they sit, and designate one tap that tested clean.
  • Flushing times are specific: 15 minutes or more after a long closure, 3 to 5 minutes after a holiday, 1 to 2 minutes for daily use.
  • At or above 1 part per billion, the level the AAP recommends not exceeding, fit a lead-certified filter and replace the faucet with a lead-free one.
  • At or above the state action level, tape over the tap, post a do-not-use sign, call the health department or utility, and use another source until it is retested.

Who it is for

School and child care administrators, building managers, and parents reading a test result.

open the PDFOpens RTI in a new tab.
  • Prevention and remediation

Help make all drinking water lead-free by 2040

Countries and organizations join the pledge as partners, committing to prevent lead leaching from new drinking water systems by 2030.

take the pledge
read the pledge